Control-Modul or Standalone-Modul

40 × 35 × ca. 28 mm | 31g

This module can be used as a standalone module if no external or additional modules are needed

It can be built with sockets, or with wires only if you want to connect the module directly yourself.

The LED in the cover can be a 5 mm LED or, if preferred, a 10 mm LED. If no LED is needed, the cover is also available without an LED hole.

The web setup also has additional settings for LED brightness and standalone mode.

Power: 7-36 Volt DC

On the 5-pin connector you would have:

1. +7V up to +36V power

2. GND

3. Tally IN, 5–15 V

4. Tally IN, short-to-ground

5. External LED

On the 3-pin connector you would have:

1. Photodiode +

2. Photodiode -

3. sense

Power, Tally-IN, Photodiode-IN,LED-OUT have the same ground

It is secured using the two small tabs on the side, either with cable ties or two screws.

The case has mounting tabs on each side. Any tabs that are not needed can be cut off.

\

Setup

TX

RX