====== Settings to transmit 8-channel sound via SRT ======

===== Add Input -> Camera, all 8 embedded chanels in the SDI signal =====
Make sure that Audio Enabled and EmbeddAllChannels are selected.\\
{{::81.png?800|}}

Then divide the individual tracks into the MABC group.. //Remember, each group (Master, A-F) has 2 channels each.//

This is done under Input Settings, General, Audio Settings
{{::82.png?300|}}




===== Channel Matrix =====
The individual SDI audio-tracks (numbers at the top of the matrix 1-8) are distributed to the groups MABC.
For listening via headphones (Headphones L/R) all tracks can remain selected, this can still be changed, but is not relevant for the sound output.
{{::83.png?800|}}



===== Output mixer  =====
In the output mixer the individual audio tracks must be switched on.
{{::84.png?800|}}


===== Receiver PC =====
The SRT input on the receiver side must have the same audio distribution settings as the SDI input from the transmitter PC,
{{::85.png?800|}}

AND also switch on all 4 groups of sound channels at the output mixer again.\\

{{::86.png?800|}}



===== Settings OUTPUT =====

Make the following settings in the output settings for External1 (Output1).
{{::87.png?800|}}

Click on the gear wheel (in our example the one next to NDI OFF/Output1) and set the audio tracks MABC on Output1.\\

ATTENTION: For the SDI Out (External 1 & 2) only 8 tones are supported.                
{{:88.png?600|}}

With the External OUT Settings (gear wheel in the footer next to the External button) also set the audio assignment MABC.
{{::89.png?800|}}